Toro TITAN HD 1500, Operator'S Manual

Page: 32 / 88

Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the
height-of-cut pin into different hole locations.
1. Move the transport lock to the L
OCK
position.
2. Push on the deck-lift pedal with your foot and
raise the mower deck to the T
RANSPORT
position
(also the 127 mm or 5 inch cutting-height
position) as shown in
Figure 35 .
3. Remove the pin from the height-of-cut bracket
(
Figure 35 ).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (
Figure 35 ).
5. Push on the deck lift, pull up on the transport
lock knob, and slowly lower the mower deck.
g036745
Figure 35
1. Deck-lift pedal 3. Height-of-cut pin
2. Height-of-cut holes 4. Transport lock knob
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake; refer to
Engaging the Parking Brake
(page 26) .
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in Figure
36 or Figure 37 .
g038079
Figure 36
2500 Series mower deck shown
1. Anti-scalp roller 4. Flange nut
2. Spacer 5. Bolt
3. Bushing
g036848
Figure 37
1500 and 2000 Series mower deck shown
1. Flange nut 4. Anti-scalp roller
2. Bolt 5. Spacer
3. Bushing
32