WARNING
The spring is under tension when installed
and can cause personal injury.
Be careful when removing the belt.
G005078
1
2
3
3
4
5
1
2
3
3
4
5
Figure 59
1.
Idler pulley
4.
Spring
2.
Mower belt
5.
Engine pulley
3.
Outside pulley
6.
Spring removal too
5.
Route the new belt around the engine pulley and
mower pulleys (
Figure 59
).
6.
Using a spring removal tool, (Toro part no. 92-5771),
install the idler spring over the deck hook and placing
tension on the idler pulley and mower belt (
Figure 59
).
Installing the Mower
1.
Park the machine on a level surface and disengage the
blade control switch.
2.
Move the motion control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Slide the mower under the machine.
4.
Lower the height-of-cut lever to the lowest position.
5.
Lift the rear of the mower deck and guide the hanger
brackets over the rear lift rod (
Figure 58
).
6.
Attach the front support rod to the mower deck with
the clevis pin and hairpin cotter (
Figure 57
).
7.
Install the mower belt onto the engine pulley; refer to
Replacing the Mower Belt.
Replacing the Grass Deflector
Service Interval:
Before each use or daily—Inspect the grass
deflector for damage
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the machine without grass deflector,
discharge cover or grass collection system in place.
Inspect the grass deflector for damage before each use.
Replace any damaged parts before use.
1.
Locate items shown in
Figure 60
.
G005303
1
2
3
4
5
6
7
Figure 60
1.
Mower deck
5.
Spring
2.
Grass deflector
6.
Nut (3/8 inch)
3.
Grass deflector bracket
7.
Short stand-off
4.
Rod
2.
Remove the nut (3/8 inch) from the rod under the
mower (
Figure 60
).
3.
Slide the rod out of the short stand-off, spring, and
grass deflector (
Figure 60
). Remove the damaged or
worn grass deflector.
4.
Replace the grass deflector (
Figure 60
).
5.
Slide rod, straight end, through the rear grass deflector
bracket.
6.
Place the spring on the rod, with end wires down, and
between the grass deflector brackets. Slide rod through
second grass deflector bracket (
Figure 60
).
7.
Insert rod at front of grass deflector into short
stand-off on deck. Secure rear end of rod into the
mower with a nut (3/8 inch) (
Figure 60
).
Important:
The grass deflector must be spring
loaded in the down position. Lift the deflector up
to test that it snaps to the full down position.
40
Summary of Contents for TimeCutter SS 4200
Page 45: ...Schematics Electrical Diagram Rev A 45 ...
Page 46: ...Notes 46 ...
Page 47: ...Notes 47 ...
