Lubrication
Greasing the Bearings
Service Interval:
Every 25 hours—Grease all lubrication
points.
Grease Type:
No. 2 General Purpose Lithium Base Grease
1.
Park the machine on a level surface and disengage the
blade control switch.
2.
Move the motion control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3.
Clean the grease fittings (
Figure 24
and
Figure 25
) with
a rag. Make sure to scrape any paint off of the front
of the fitting(s).
1
G014522
Figure 24
1.
Front caster tire
Figure 25
Located on the seat pan underside
1.
Read the instructions
before servicing or
performing maintenance.
3.
Grease every 25 operating
hours.
2.
Check tire pressure every
25 operating hours.
4.
Engine
4.
Connect a grease gun to each fitting (
Figure 24
and
Figure 25
). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5.
Wipe up any excess grease.
Engine Maintenance
Servicing the Air Cleaner
Service Interval:
Before each use or daily—Clean and check
the air cleaner foam element.
Every 50 hours—Replace the air cleaner paper
element.
Note:
Service the air cleaner more frequently if the operating
conditions are extremely dusty or sandy.
Removing the Foam and Paper
Elements
1.
Disengage the blade control (PTO).
2.
Stop the engine, wait for all moving parts to stop, and
remove the key before leaving the operating position.
3.
Clean around the air cleaner to prevent dirt from
getting into the engine and causing damage.
4.
Remove the air cleaner cover by unscrewing the 2
knobs (
Figure 26
).
G017862
Figure 26
1.
Air cleaner cover
2.
Knobs
5.
Carefully remove the foam and paper filter elements
from the air cleaner housing (
Figure 27
).
25
Summary of Contents for TimeCutter SS 4200
Page 45: ...Schematics Electrical Diagram Rev A 45 ...
Page 46: ...Notes 46 ...
Page 47: ...Notes 47 ...
