Releasing the Electric Brake
The electric brake releases by manually rotating the link arms
forward. Once the electric brake is energized the brake will
reset.
To release the brake:
1.
Turn the ignition key to the Off position or disconnect
the battery.
2.
Locate the shafts where the brake-link arms are
connected on both sides of the electric brake (
Figure
44
).
3.
Rotate the shafts forward to release the brakes.
Figure 44
1.
Rotate brake-link arm forward on the electric-brake-control
module
2.
Left rear tire
Cooling System
Maintenance
Cleaning the Engine Screen
Service Interval:
Before each use or daily—Clean the engine
air intake screen.
To ensure proper cooling, make sure the grass screen, cooling
fins, and other external surfaces of the engine are kept clean
at all times.
Use a dry brush to clean grass and accumulated debris from
the air intake screen and around the engine.
Important:
To prevent contaminating the fuel system,
do not use water to clean the engine.
Cleaning the Engine Cooling
Fins and Shrouds
Service Interval:
Every 100 hours—Clean the engine cooling
fins and shrouds.
1.
Disengage the blade control switch and move the
control levers to the neutral locked position and apply
the parking brake.
2.
Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3.
Remove the air intake screen and cooling shrouds.
4.
Clean the debris and grass from the engine parts.
5.
Install the air intake screen and cooling shrouds.
34
Summary of Contents for TimeCutter SS 4200
Page 45: ...Schematics Electrical Diagram Rev A 45 ...
Page 46: ...Notes 46 ...
Page 47: ...Notes 47 ...
