Toro TimeCutter 74726, Operator'S Manual

Page: 29 / 64

Adjusting the Height of Cut
Note:
The transport position is the highest
height-of-cut position or cutting height at 115 mm
(4-1/2 inches) as shown in
Figure 29 .
Height of cut is controlled by the lever located to the
right of the operating position (
Figure 29 ).
g028025
Figure 29
Adjusting the Anti-Scalp
Rollers
Machines with a 107 cm (42 inch),
127 cm (50 inch), or 137 cm (54
inch) Mower Deck Only
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
EUTRAL
-L
OCK
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in Figure
30 to match the closest height-of-cut position.
g010233
Figure 30
1. Anti-scalp roller 3. Flange nut
2. Bolt 4. Hole spacing
Machines with a 152 cm (60 inch)
Mower Deck Only
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
EUTRAL
-L
OCK
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the flange nut, anti-scalp roller, and bolt
from the bracket (
Figure 31 ).
Note:
Keep the bolt and anti-scalp roller
together when removing.
29