Toro Super Recycler 20062, Operator'S Manual

Page: 14 / 20

Charging the Battery
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after handling
battery.
Charge the battery for 24 hours initially, then monthly
(every 25 starts) or as needed. Always use the charger in a
sheltered area and charge the battery at room termperature
(70
°
F or 22
°
C) whenever possible.
1. Connect the charger to the mower wire harness located
below the ignition key (Figure 39).
Figure 39
2. Plug the charger into a wall outlet.
Note:
When the battery no longer holds a charge, recycle
or dispose of the lead-acid battery according to local codes.
Replacing the Fuse
If the battery does not charge or the engine does not turn
with the electric starter, the fuse may be blown. Replace it
with a 40-amp plug-in type fuse. Refer to Installing the Fuse.
Lubricating the Wheel Gears
Lubricate each rear wheel with grease yearly.
1. Wipe the grease fittings just inside the rear wheels with
a clean rag (Figure 40).
Figure 40
2. Install a grease gun onto each fitting and gently apply 2
or 3 pumps of #2 multi-purpose lithium-base grease.
Replacing the Blade
Important:
You will need a torque wrench to install
the blade properly. If you do not have a torque wrench
or are uncomfortable performing this procedure,
contact an Authorized Service Dealer.
Examine the blade whenever you run out of gasoline. If the
blade is damaged or cracked, replace it immediately. If the
blade edge is dull or nicked, have it sharpened or replace it.
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
1. Disconnect the spark plug wire from the spark plug.
Refer to Preparing for Maintenance.
2. Tip the mower onto its side with the air filter up.
3. Use a block a wood to hold the blade steady (Figure 41).
Figure 41
4. Remove the blade, saving all mounting hardware.
5. Install the new blade and all mounting hardware.
Important:
Position the curved ends of the blade
to point toward the mower housing.
6. Use a torque wrench to tighten the blade bolt to
60 ft-lb (82 N
⋅
m).
14