Toro Reelmaster 5010- H, Installation Instructions Manual

Page: 9 / 16

Installing the High
Height-of-Cut Brush
(Optional)
Install the high height-of-cut brush (sold separately)
when the height of cut is 2.5 cm (1 inch) or more (5 or
more spacers installed below the side-plate pad).
1. If a roller brush is installed on the cutting
unit, remove the 2 bolts, washers, and nuts
securing the non-drive-bearing housing to the
bearing-housing mounting bracket (
Figure 18
and Figure 19 ).
g027200
Figure 18
1. Non-drive-bearing housing
2. Slide the non-drive-bearing housing and the
excluder seal off the brush shaft (
Figure 19 ).
g027201
Figure 19
1. Non-drive-bearing housing
3. Brush shaft
2. Excluder seal
3. Remove the 2 J-bolts and the nuts ( Figure 20 ).
4. Slide the existing brush off the brush shaft
(
Figure 20 ).
5. Loosen the 2 bolts, washers, and nuts securing
the drive-bearing housing to the bearing-housing
mounting bracket (
Figure 20 ).
6. Slide the high height-of-cut brush onto the brush
shaft (
Figure 20 ).
7. Clamp the brush onto the shaft with the 2 J-bolts
and nuts previously removed (
Figure 20 ).
Important:
Insert the threaded end of the
J-bolts through the outer holes of the brush
shaft while hooking the curved ends of the
J-bolts into the inner holes.
8. Torque the J-bolt locknuts to 2 to 3 N∙m (20 to
25 in-lb).
g027202
Figure 20
1. High height-of-cut brush
3. Loosen these bolts.
2. J-bolts
9. Install the excluder seal and the
non-drive-bearing housing onto the brush
shaft (
Figure 19 ).
10. Mount the non-drive-bearing housing to the
bearing-housing mounting bracket with the 2
bolts, washers, and nuts previously removed.
Note:
Be careful not to knock the seal spring
off.
11. Tighten the 2 bolts, washers, and nuts securing
the drive-bearing housing to the bearing-housing
mounting bracket.
9