Toro Reelmaster 5010- H, Installation Instructions Manual

Page: 7 / 16

3. Tighten the 2 bolts securing each
roller-brush-bearing housing to the roller-brush
mounting brackets.
Installing the Drive Pulley
and the Belt
1. Restrain the reel for installation; Restraining the
Reel for Installing Threaded Inserts (page 12) .
2. Install the drive pulley onto the groomer shaft
(
Figure 13 ).
g192352
Figure 13
1. Drive pulley 2. Flange-head bolt—torque
to 20 to 26 N∙m (15 to 19
ft-lb)
3. Apply 242 Loctite (blue) to the flange-head bolt
and use the bolt to secure the pulley to the
driveshaft; refer to
Figure 13 .
Note:
Torque the bolt to 20 to 26 N∙m (15 to
19 ft-lb) .
Important:
If you do not properly torque the
bolt, the bolt will come loose.
4. Install the belt onto the pulleys as follows:
•
Loop the belt around the drive pulley and
then over the top of the idler pulley ( Figure
14 ).
g192353
Figure 14
1. Drive pulley 3. Belt
2. Idler-pulley assembly 4. Driven pulley
•
Start the belt on the driven pulley ( Figure
15 ).
•
Use a 9/16-inch deep-well socket to rotate
the brush assembly and guide the belt onto
the driven pulley (
Figure 15 ).
g020390
Figure 15
1. Belt 2. 9/16-inch deep-well socket
Important:
Ensure that the ribs on the belt
are properly seated in the grooves in each
pulley and that the belt is in the center of the
idler pulley.
7