Installing the Additional
Weight Parts Not Included
in the Kit (5-inch Electrically
Driven Cutting Units; 7-inch
Hydraulically or Electrically
Driven Cutting Units)
Install the weight parts to the cutting unit as shown in
; refer to
Additional Parts That Need to be
.
If installing brush kit 133-0153, discard the weight and
fasteners included with the brush kit (do not use).
g032168
Figure 6
Additional parts that need to be ordered
5-inch electrically driven,
7-inch hydraulically or electrically driven
1.
Weight plate
4.
Washers (5/16 inch)—Part
No. 3256-23
2.
Carriage bolts (5/16 x 2
inch)—Part No. 3230-6
5.
Flange nuts (5/16
inch)—Part No. 104-8300
3.
Bolts (5/16 x 1/2
inch)—Part No. 322-1
6.
Weight—Part No.
132-0735-03
Additional Parts That Need to be Ordered
Part
Part No.
Quantity
Weight
132-0735-03
1
Carriage bolt
3230-6
2
Bolt
322-1
2
Washer
3256-23
2
Flange nut
104-8300
2
Installing the Roller-Brush
Plate
1.
Slide the excluder seal outward until the lip seals
are in light contact with each bearing housing
(
).
g027192
Figure 7
1.
Bearing housing
2.
Excluder seal
2.
Remove the cap from the groomer drive box.
g283858
Figure 8
1.
Cap
3.
Ensure that the roller-brush pivot plate is
configured so that the idler-pulley assembly is
installed on the bottom as shown in
To change the roller-brush pivot plate to a
right-drive configuration, refer to
.
4
