5
Connecting the
Supply/Return Hoses
to the Tow Vehicle
Parts needed for this procedure:
1
Supply hose
1
Return hose
1
Female dust cap
1
Male dust cap
Procedure
1.
Screw the quick couplers (included in loose
parts) to the tow vehicle couplers.
2.
Remove the dust caps from the supply/return
hoses.
Note:
Hang the dust caps on the supply/return
hoses so they may be used whenever the hoses
are uncoupled from the vehicle.
3.
Couple the supply hose to the pressure port of
vehicle system.
Note:
It is possible to connect one male and
one female coupler to the vehicle to ensure that
the hoses can not be connected incorrectly.
4.
Couple the return hose to the return port or tank
on the tractor system.
Note:
The return hose has an inline check
valve visible near the coupler.
Important:
Consult your vehicle
Operator’s
Manual
for the proper installation of the
hoses because damage may occur if the
hoses are improperly installed.
6
Installing Reelmaster
Mowers
Parts needed for this procedure:
10
Capscrew (1/2 x 3-1/2 inch)
10
Spacer
10
Locknut (1/2 inch)
4
Long shackles
4
Clevis pin (3/8 x 1-1/2 inch)
4
Cotter pin (1/8 x 3/4 inch)
1
Capscrew (3/8 x 1-1/2 inch)
1
Locknut (3/8 inch)
5
Spring
5
S-hook
Procedure
1.
Align the holes in the draw bar with the brackets
on the mower cross-tubes. Secure each side
with a capscrew (1/2-13 x 3-1/2 inch ), spacer
tube, and locknut (1/2-13) as shown in in
Note:
The head of the capscrew should be
positioned inboard.
g012761
Figure 12
1.
Capscrew, spacer tube,
and locknut
2.
Mounting bracket
Note:
If you are attaching Spartan mowers,
draw bar clamps (Part no. 5-1090) and mounting
fasteners are required to mount the draw bar to
the front cross tube of the mower. Contact your
local authorized Toro distributor for assistance.
11
