Toro Reelmaster 33455, Operator'S Manual

Page: 9 / 28

3. Adjust the control tower forward or backward by
sliding the tower on the center frame tube and
tightening the flange nuts and U-bolts.
Important:
Position the tower in a
comfortable position for the operator, within
reach. The tower will pitch forward when
crossing a ditch or low area in turf.
4. Route the supply and return hoses through the
hose hanger (
Figure 6 ).
g012755
Figure 6
1. Supply and return hoses 2. Hose hanger
4
Mounting the Control
Linkage and Levers
Parts needed for this procedure:
3 Control levers with knobs
3 Hex nut
3 Clevis pin (5/16 x 1-1/4 inch)
6 Cotter pin (5/32 x 3/4 inch)
Procedure
1. Remove the control-panel cover from the control
tower by removing the 4 capscrews (
Figure 8 ).
2. Secure the upper control linkage tubes to the
pivot blocks with the clevis pins and cotter pins
(
Figure 7 ).
3. Coat the clevis pins with No. 2 lithium grease.
g316644
Figure 7
1. Upper control linkage tube 4. Cotter pin
2. Clevis pin 5. Control lever connection
hole
3. Pivot block
4. Install the control-panel cover to the control
tower with the 4 corresponding capscrews
(
Figure 8 ).
g316580
Figure 8
1. Control-panel cover 3. Capscrews
2. Control levers
5. Screw the control levers into the pivot blocks
(
Figure 7 and Figure 8 ).
6. Ensure that the valve-spool levers ( Figure 9 ) are
in neutral (middle position) by pivoting the levers
9