Important:
After disconnecting the
supply/return hose couplers from the tow
vehicle valve, always return the tow vehicle
hydraulic-directional-control-valve lever
to neutral. This deactivates the "remote"
hydraulic feature.
2.
Closed center hydraulic system on the tow
vehicle and open center hydraulic system on
the transport frame.
•
Connect the supply and return hoses to the
tow vehicle valve couplers.
•
Start the tow vehicle.
•
The tow vehicle hydraulic-directional-control
lever must be actuated simultaneously with
the control levers on the transport frame.
Do not restrain the tow vehicle valve lever
permanently as damage may occur to the
system.
•
Raise or lower the mowers using the control
levers.
Note:
If the mowers will not raise or
lower, the supply and return hoses may be
reversed. Reinstall the couplers reversing
the position. Mark the hoses for future
identification, or connect a male and female
coupler section to the transport hoses to
prevent reversal.
Tow Vehicle Controls
Become familiar with operating the following tractor
controls before you operate the transport frame:
•
PTO engagement
•
Engine/PTO speed
•
The rear attachment control (raise/lower)
•
Auxiliary valve operation
•
Clutch
•
Throttle
•
Gear selection
•
Parking brake
Important:
Refer to the tow vehicle Operator's
Manual for operating instructions.
Outcross Traction Unit Controls
Refer to the Outcross traction unit
Operator’s Manual
for information on controls and operation, as well as
additional information on setting up the vehicle for this
attachment.
Specifications
Note:
Specifications and design are subject to
change without notice.
Tow Vehicle Specification
Minimum weight
1,360 kg (3,000 lb)
Minimum PTO output-power
rating
22.4 kW (30 hp)
Minimum hydraulic
pressure
10,342 kPa (1,500 psi)
Tow system
Drawbar and pin—25 mm (1
inch) diameter
Transport Frame Specification
Length
381 cm (150 inches)
Transport Width
241 cm (95 inches) with
Reelmaster mowers
Mowing Width
436 cm (172 inches) with
Reelmaster mowers
Height
147 cm (58 inches) with the
control tower collapsed
Tread Width
173 cm (68 inches)
Transport Ground
Clearance
19 cm (7-1/2 inches)
Net Weight
628 kg (1,384 lb)
Maximum Transport Speed
32 kph (20 mph)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com
for a list of all approved attachments
and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
14
