EN–17
6.
Clean dirt and chaff from cylinder, cylinder head
fins, and blower housing. Also remove grass
clippings, dirt, and grime from external parts of
the engine, shrouding, and top of mower
housing.
7.
Check condition of blade: refer to
Inspecting/Removing/Sharpening Blade,
page 12.
8.
Tighten all nuts, bolts, and screws.
9.
Clean air cleaner: refer to Servicing Air Cleaner,
page 10.
10. Lubricate the pivot arms: refer to Lubrication,
page 13.
11. Touch up all rusted or chipped paint surfaces.
Toro Re–Kote paint is available from an
Authorized TORO Service Dealer.
12. Fill crankcase with oil: refer to Fill Crankcase
With Oil, page 5.
13. Store mower in a clean, dry place, out of the
reach of children. Cover mower to keep it clean
and protected.
Accessories
For special conditions, the following accessories may
be purchased at your local Authorized Toro Service
Dealer.
1.
Side Discharge Kit, Model No. 59199—Installs
in seconds. Rear mounted in place of the grass
bag or discharge tunnel plug. Disperses clippings
while trimming on both sides (Fig. 35).
2.
Spark Arrestor and Screw (Part No.
94–1681)—If a spark arrestor is required
because of local, state, or federal regulations, it
may be purchased at your local Authorized
TORO Service Dealer. Clean screen after every
75 hours of operation. If mower is operated on
any California forest, brush, or grass covered
land without a properly operating spark arrestor,
the operator is violating state law, Section 4442
Public Resources Code.
