Toro Recycler 20012, Service Manual

Page: 64 / 144

3-26 WPM Drive Systems Manual
SINGLE SPEED BEVEL GEAR TRANSMISSION
7. When installing the rear cover, note the bosses on
the back side of the cover. They must go behind the
notch in the chassis to secure the cover. The top of
the cover is retained with screws (Fig. 113).
Fig 113 MVC-303
A. Boss B. Notch
Note: Wheel Clutch Service - see Spring Ratchet
Key Style Clutch, page 5-8. Control Cable
Adjustment - see Handles & Control Cables.
A
B
5. Make sure the stepped washer is properly seated
in the wheel cover. The best way is to assemble the
wheel, wheel cover, and wheel bolt, then put them all
on the mower together.
6. Do not use an impact wrench on the crankshaft belt
guide screws. Over-tightening can cause the belt
guide to deform and cause the belt not to declutch
properly. Tighten fi rmly with a ratchet.
4. The wheel pinion is marked with an R and L for right
and left. Identify right and left from the operator’s
position (Fig. 112). On the right side, the R should
face outward. The letter L should face outward on
the left side. If the wheel pinions are reversed, the
wheels will not drive.
Fig 112 MVC-474
R