3-14
WPM Drive Systems Manual
SINGLE SPEED BEVEL GEAR TRANSMISSION
21. Pull the belt towards the crankshaft and remove.
If only the belt is to be replaced, install a new one
now. Reverse the process to assemble.
If transmission service is necessary proceed as
follows.
19. Clamp the axle with locking pliers and remove the
pulley nut and transmission pulley (Fig. 075).
Do not bend the belt guide. The pulley must be lifted
up slightly to slip the belt off.
18. Pull the belt cover out from under the rear wall and
the belt is exposed (Fig. 074).
Fig 074
MVC-745
Fig 076
MVC-741
20. The cable may be unhooked from the arm on the
transmission to help prevent cable damage (Fig.
076).
Note: It is not necessary to remove the transmission
to replace the control cable.
Fig 075
MVC-740
Summary of Contents for Recycler 20012
