7-15
WPM Drive Systems Manual
HANDLES AND CONTROL CABLES
1. Remove the two fl anged head self-tapping screws
securing the screen panel to the housing and
remove the screen panel (Fig. 262).
BBC Cable Adjustment (Toro Vacu Power/
Lawn-Boy Medallion)
2. With the engine off and the spark plug wire discon-
nected, cock and lift the control bar to engage the
blade. Tape the control bar to the handle with the
blade engaged, then measure the length of the over-
travel spring (Fig. 263). When adjusted properly, it
should measure 1” (25mm). If it does, skip ahead
to step 5. Otherwise proceed with adjustment in the
following step.
Fig 263
fi
g.
68
A. Plastic
fi
tting
C. Spring
B. Cable
fi
tting
Fig 262
3428-0079
3. There is a turnbuckle in the cable about halfway
between the control panel and the chassis. Adjust
the turnbuckle until the over-travel spring measures
1” (25mm).
4. Remove the tape from the handle and disengage the
blade.
1”
Summary of Contents for Recycler 20012
