12
Adjust Rake Depth
Flex tip reel should be adjusted so rake tips slightly touch
surface but do not penetrate turf. If rake tips penetrate turf,
improper debris pickup could result.
1.
Position sweeper on a level surface.
2.
Loosen locknut on depth adjustment bolt so it can be
turned.
1
Figure 7
1. Locknut
3.
Turn depth adjustment bolt until rake slightly contacts
top of turf grass. If a broom is installed, slight contact
should be made with surface. When broom is operating,
the contact width surface should be about 1” wide
across entire length of broom.
1
Figure 8
1. Depth adjusting bolt
4.
Repeat procedure on opposite side of machine.
5.
Retighten adjustment lock nut.
Adjust Rubber Flap
For best debris pick up results, metal portion of front flap
should be vertical to ground.
1.
Move flat lever forward to lower flat.
2
1
Figure 9
1. Rubber flap
2. Metal edge
2.
Loosen jam nut on top of stop and rotate adjustment
bolt up or down until flap is vertical to ground.
2
1
Figure 10
1. Adjustment bolt
2. Stop
3.
Tighten jam nut to secure adjustment.
Note:
Flap may be positioned in raised position when
picking up large amounts of leaves.
Summary of Contents for RAKE-O-VAC 07050
Page 6: ...6 92 8309 93 4041...
