9
Incorrect battery cable routing could damage the
tractor and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
•
Always
disconnect
the negative (black) battery
cable before disconnecting the positive (red)
cable.
•
Always
connect
the positive (red) battery cable
before connecting the negative (black) cable.
Warning
3.
Attach the positive cable (wire from ignition switch) to
the positive (+) terminal.
4.
Coat the terminals and mounting fasteners with
petroleum jelly to prevent corrosion.
5.
Install battery cover and secure with springs.
Mount Sweeper To Prime
Mover
To assure proper debris pickup, make sure sweeper frame is
parallel with the ground.
1.
Position sweeper on a flat, level surface.
2.
Insert sweeper jack caster wheel onto sweeper end of
jack tube.
3.
Adjust sweeper jack so distance from top of frame to
ground is approximately 23–1/2” (Fig. 2).
4.
Back prime mover up to sweeper.
5.
Adjust sweeper hitch tongue to same level as hitch of
prime mover as follows:
•
Remove capscrews and locknuts securing hitch
tongue to frame (Fig. 2).
•
Raise or lower hitch tongue to position
approximately level with prime move hitch and
secure with (2) capscrews and locknuts.
1
2
23–1/2”
3
Figure 2
1. Sweeper jack
2. Hitch tongue
(Model 07050)
3. Adjusting screws
Removing Sweeper From
Prime Mover
Always empty sweeper hopper before
disconnecting hopper from prime mover or
sweeper may tip backwards and cause injury.
Warning
1.
Park sweeper on a level surface and block wheels.
2.
Insert castor wheel onto jack tube.
3.
Raise sweeper jack handle and lower caster wheel to
ground.
4.
Continue to raise sweeper with jack until hair pin cotter
and hitch pin can be removed from hitch.
Summary of Contents for RAKE-O-VAC 07050
Page 6: ...6 92 8309 93 4041...
