Operating the Traction
Drive
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust
it properly, if necessary; refer to
the Operation of the Traction Drive (page 13)
for more information.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 24)
or take the machine
to an Authorized Service Dealer for service.
1.
To engage the traction drive, squeeze the left
(traction) lever to the handgrip (
g322974
Figure 21
2.
To stop the traction drive, release the traction
lever.
Operating the Speed
Selector
The speed selector has 6 forward and 2 reverse
gears. To change speeds, release the traction lever
and shift the speed-selector lever to the desired
position (
). The lever locks in a notch at
each speed selection.
g322971
Figure 22
Operating the
Auger/Impeller Drive
1.
To engage the auger/impeller drive, move back
the lock switch on the lever, then squeeze the
right (auger/impeller) lever to the handgrip
(
).
g360687
Figure 23
2.
To stop the auger and impeller, release the right
lever.
Important:
When you engage both the
auger/impeller lever and the traction lever,
the traction lever locks the auger/impeller
lever down, freeing your right hand. To
release both levers, simply release the left
(traction) lever.
3.
If the auger and impeller continue to rotate when
you release the auger/impeller lever, do not
19
