Toro LT3340, Operator'S Manual

Page: 16 / 64

Service (cont'd.)
Menu Item Description
Backlap Use to turn backlap on or off
Inhibit Regen Use to control reset
regeneration
Parked Regen Use to initiate a parked
regeneration
Last Regen Lists the number hours since
the last reset, parked, or
recovery regeneration
Recover Regen Use to initiate a recovery
regeneration
Settings
Menu Item Description
Units Controls the units used on the
InfoCenter (English or Metric)
Language Controls the language used
on the InfoCenter*
LCD Backlight Controls the brightness of the
LCD display
LCD Contrast Controls the contrast of the
LCD display
Protected Menus
Allows an authorized person
with the PIN code to access
protected menus
Protect Settings
Allows the ability to change
the settings in the protected
settings
Limited Lift Reverse Turns on or off limited lift
reverse
Slope Sensor Installed
Indicates a slope sensor is
detected in the machine.
Turnaround
Turns on or off turnaround for
cutting units
Accessible only by entering PIN
About
Menu Item Description
Model Lists the model number of the
machine
SN Lists the serial number of the
machine
Machine Controller Revision Lists the software revision of
the master controller
InfoCenter Revision
Lists the software revision of
the InfoCenter
CAN Bus
Lists the machine
communication bus status
Accessible only by entering PIN
Diagnostics
Menu Item Description
Engine Run
Decks Raise
Decks Lower
PTO
Traction
Refer to the Service Manual
or your authorized Toro
distributor for more information
on the Engine Run menu and
the information contained
there.
Protected Menus
There are operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter.
To lock these settings, use the Protected Menu.
Note:
At the time of delivery, the initial password code
is programmed by your authorized Toro distributor.
Accessing Protected Menus
Note:
The factory default PIN code for your machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M
AIN
M
ENU
, use the center button to
scroll down to the S
ETTINGS
M
ENU
and press the
right button ( Figure 17 ).
g028523
Figure 17
2. In the S
ETTINGS
M
ENU
, use the center button to
scroll down to the P
ROTECTED
M
ENU
and press
the right button ( Figure 18 A).
16