Figure 58
1.
Drain plug location
5. Clean the area around the drain plug on the bottom
of the gear box (Figure 59).
6. Remove the drain plug from the gear box and allow
the oil to drain into a pan. Remove the fill plug to
ease in draining of the oil.
Figure 59
1.
Drain plug
7. Add enough oil to bring the level up to the bottom
of the check plug holes; refer to Checking the Rear
Axle Lubricant, and Checking the Rear Axle Gear
Box Lubricant.
8. Install the plugs.
Checking the Rear Wheel
Toe-In
Service Interval:
Every 800 hours
After every 800 operating hours or annually, check the
rear wheel toe-in.
1. Measure the center-to-center distance (at axle height)
at the front and rear of the steering tires. The front
measurement must be 1/4 inch (6 mm) less than the
rear measurement.
2. To adjust, loosen the clamps at both ends of the tie
rods.
3. Rotate the tie rod end to move the front of the tire
inward or outward.
4. Tighten the tie rod clamps when the adjustment is
correct.
44
Summary of Contents for Groundsmaster 4100-D 30411
