![Toro Groundsmaster 4100-D 30411 Operator'S Manual Download Page 16](http://html1.mh-extra.com/html/toro/groundsmaster-4100-d-30411/groundsmaster-4100-d-30411_operators-manual_1133579016.webp)
load, maximum ground speed, fully press the pedal while
the throttle is in Fast.
To stop, reduce your foot pressure on the traction pedal
and allow it to return to the center position.
Important:
The speed limiter screw must stop the
traction pedal before the pump reaches full stroke
or damage to the pump may occur.
Brake Pedals
Two foot pedals (Figure 2) operate individual wheel
brakes for turning assistance, parking, and to aid in
obtaining better side hill traction. A latch connects the
pedals for parking brake operation and transport.
Pedal Locking Latch
The pedal locking latch (Figure 2) connects the pedals
together to engage the parking brake.
Tilt Steering Lever
Press the lever (Figure 2) down to tilt the steering wheel
to the desired position. Then release the lever to lock
the adjustment.
Parking Brake Latch
A knob on the left side of the console actuates the
parking brake lock (Figure 2). To engage the parking
brake, connect the pedals with the locking latch, push
down on both pedals, and pull the parking brake latch
out. To release the parking brake, press both pedals until
the parking brake latch retracts.
Charge Indicator
The charge indicator (Figure 2) illuminates when the
system charging circuit malfunctions.
Engine Oil Pressure Warning Light
The light (Figure 2) illuminates when the engine oil
pressure is dangerously low.
Engine Coolant Temperature Warning
Light
The light (Figure 2) illuminates and the engine shuts
down when coolant reaches an excessively high
temperature.
Glow Plug Indicator Light
When lit, the glow plug indicator light (Figure 2)
indicates that the glow plugs are on.
Engine Temperature Gauge
This gauge (Figure 2) indicates the engine coolant
temperature.
Speed Limiter
Adjust the screw (Figure 3) to limit the amount the
traction pedal can be depressed in the forward direction
to limit speed.
Important:
The traction pedal must contact the
speed limiter before reaching the end of the pump
stroke to prevent pump damage.
Figure 3
1.
Speed limiter
Lift Levers
The lift levers (Figure 4) raise and lower the cutting units.
Important:
The center lift lever must momentarily
be pushed to the lower position to enable PTO
circuit actuation by PTO switch.
Cutting Unit Service Lock
The cutting unit service lock (Figure 4) locks the front
cutting unit lift lever when the cutting unit is in the
raised position.
Key Switch
The key switch (Figure 4) has three positions: Off,
On/Preheat, and Start.
16
Summary of Contents for Groundsmaster 4100-D 30411
