g010786
Figure 9
1.
Front castor wheel
3.
Spacers
2.
Tensioning cap
4.
Thrust washers
2.
Remove the washer from the spindle shaft.
3.
Slide the spacers onto the spindle shaft to get
the desired height of cut, then slide the washer
onto the shaft.
4.
Push the castor spindle through the front castor
arm.
5.
Install the other thrust washer and remaining
spacers onto the spindle.
6.
Install the tensioning cap to secure the assembly.
Adjusting the Rear Castor Wheels
1.
Remove the tensioning cap securing the gage
wheel to the cutting unit brackets (
g010787
Figure 10
1.
Rear castor wheel
3.
Spacers
2.
Tensioning cap
4.
Thrust washers
2.
Remove or add ”C” shaped spacers at the
narrow portion of the spindle shaft, below the
castor arm, to get the desired height of cut.
Note:
Ensure that the thrust washers, not the
spacers, contact the top and bottom of the
castor arm.
3.
Install the tensioning cap to secure the assembly.
Note:
Ensure that all 4 castor wheels are set at
the same height of cut.
13
