Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
Front castor wheel assembly
2
1
Rear castor wheel assembly
2
Install the castor wheel assemblies.
Right lift arm
1
Left lift arm
1
Pivot pin
2
2
Cotter pin (5/32 x 1-3/4 inches)
2
Install the lift arms.
3
No parts required
–
Connect the lift arms to the cutting unit.
4
No parts required
–
Connect the PTO shaft and guard to the
cutting unit gearbox.
5
No parts required
–
Install the rear weight.
6
No parts required
–
Grease the machine.
Media and Additional Parts
Description
Qty.
Use
Operator's Manual
1
Review the material and save in an appropriate place
Parts Catalog
1
Use to reference part numbers
WARNING
If you leave the key in the ignition switch,
someone could accidentally start the engine
and seriously injure you or other bystanders.
Remove the key from the ignition switch
before you do any maintenance.
DANGER
If the engine is started and the PTO shaft is
allowed to rotate, serious injury could result.
Do not start the engine and engage the PTO
lever when the PTO shaft is not connected to
the gearbox on the cutting unit.
Note:
Determine the left and right sides of the
machine from the normal operating position.
Note:
When installing the 62-inch deck onto a
Groundsmaster 200 Series traction unit, you must
install the Weight Transfer Kit, Toro Part No. 70-8100.
1
Installing the Castor Wheel
Assemblies
Parts needed for this procedure:
2
Front castor wheel assembly
2
Rear castor wheel assembly
Procedure
Note:
The thrust washers, spacers, and tensioning
caps have been installed on the castor wheel spindles
for shipping.
1.
Remove the tensioning caps from the spindle
shafts and slide off the spacers and thrust
washers (
and
).
8
