Toro Groundsmaster 3300 Series, Operator'S Manual

Page: 56 / 68

Replacing the Traction Belt
g300570
Figure 69
1. Traction belt 4. Idler pulley
2. Insert ratchet here. 5. Engine pulley
3. Pump pulley
Removing the Traction Belt
1. Disconnect the PTO shaft from the attachment
gearbox; refer to your attachment
Operator’s
Manual .
2. Unplug the clutch-wire-harness connector from
the machine wire harness (
Figure 70 ).
g300592
Figure 70
1. Clutch wire harness 3. Bolt, washer, and nut
2. Rubber strap
3. Remove the bolt, washer, and nut from the
rubber strap (
Figure 70 ) on the frame.
4. Have an assistant use a ratchet to release
tension from the belt, then remove the belt from
the pump pulley, idler pulley, and engine pulley.
5. Move the belt over the clutch and forward on the
PTO shaft.
Installing the Traction Belt
1. Move the belt along the PTO shaft, over the
clutch, and onto the engine pulley..
2. Have an assistant use a ratchet to pull the idler
pulley down.
3. Route the belt on the engine pulley, idler pulley,
and pump pulley (
Figure 69 ).
4. Remove the ratchet from the idler arm.
5. Use the previously removed bolt, washer, and
nut to secure the end of the rubber strap to the
frame.
6. Plug in the clutch-wire-harness connector to the
machine wire harness.
56