Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
2
No parts required
–
Remove the mower deck.
3
No parts required
–
Position the casters.
4
Lock bracket assembly
1
Install the lock bracket.
Snowthrower attachment
1
Stop block
2
Chute-cable bracket
1
Carriage bolt (3/8 x 1-1/2 inches)
2
Carriage bolt (5/16 x 4 inches)
1
Nut (3/8 inch)
2
Nut (5/16 inch)
1
5
Washer
2
Install the snowthrower.
6
High Flow Case Drain Kit
1
Install the High Flow Case Drain Kit
7
No parts required
–
Connect the hoses.
8
No parts required
–
Set the snowthrower height.
Install the following (sold separately on your machine
before you install the snowthrower:
•
Float Kit (optional)
•
High Flow Hydraulic Kit (required)
•
Low Flow Hydraulic Kit (required)
•
Pneumatic casters (required)
•
Snow Tires (recommended)
•
Wheel Weight Kit (required)
A Lift Cylinder Lock Kit (Part No. 137-4106) is
available to secure the A-frame when you raise it for
setup or maintenance; contact your Authorized Toro
Dealer.
Reverse the procedures to remove the snowthrower
after installation.
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Disengage the PTO, engage the parking brake,
and move the motion-control levers outward to
the N
EUTRAL
-L
OCK
position.
3.
Raise the A-frame and support it using blocks
or a cylinder lock.
4.
Shut off the engine and remove the key.
5
