Adjusting the Neutral Position for the
Motion-Control Levers
Important:
Ensure the tracking of the mower is correct
after adjusting the motion-control levers. Adjusting the
tracking and aligning the motion-control levers front to
back is the same procedure (
Note:
Adjust the horizontal alignment before the front to
back alignment.
If the motion-control levers do not align front to back, or
the right side control lever does not move easily into the
neutral-lock position, adjustment is required.
1.
After the horizontal alignment is finished, check the
front to back alignment by slightly pushing the control
levers forward to take up any slack in the linkage for
the control levers (
).
G012706
1
2
3
4
Figure 73
1.
Left motion-control lever
3.
Neutral-locked position
2.
Right motion-control lever
4.
Align the control levers
front to back
2.
Ensure the right motion-control lever moves easily into
the neutral-lock position.
Note:
Turn the cable adjustment clockwise to
move the motion-control handle forward. Turn
the cable adjustment counterclockwise to move the
motion-control handle rearward.
3.
Rotate the cable adjustment on right side when
adjustment is needed.
Note:
Adjust the cable adjustment in quarter-turn
increments.
4.
After the right motion-control lever moves easily into
the neutral-lock position, adjust the left motion-control
lever to align with the right motion-control lever.
5.
Check for proper tracking; refer to
Tracking (page 40)
.
6.
Install the cable lock onto the cable-adjusting nuts to
secure the adjustment (
3
g017848
Figure 74
1.
Left cable adjustment
3.
Right cable adjustment
2.
Cable lock
50
Summary of Contents for GrandStand 74574
Page 65: ...g026979 Electrical Schematic Rev A 65 ...
Page 66: ...Notes 66 ...
Page 67: ...Notes 67 ...
