Toro 79398, Operator'S Manual

Page: 7 / 20

6. On the right side of the machine, install the right
weight-mounting bracket as follows:
•
For machines without a foot assist lift pedal,
secure the bracket using 2 bolts (3/8 x 1-1/4
inches), 2 washers and 2 locknuts (3/8 inch)
as shown in
Figure 8 .
Note:
A locknut is from loose parts and the
other is used from earlier removal.
g014876
Figure 8
1. Front, right caster (caster
fork and wheel not shown
for clarity) 5. Bolt (3/8 x 1-1/4 inches)
2. Forward hole on the right
side 6. Washer
3. Existing locknut (3/8 inch) 7. Existing hole in the frame
4. Right mounting bracket
8. Locknut (3/8 inch) from
loose parts
Note:
For machines with a foot assist lift
pedal, the washers are not used.
•
For machines with a foot assist lift pedal,
Remove the forward fasteners in the foot
assist lift pedal bracket and secure the
bracket using 2 bolts and 2 locknuts (
Figure
9 ).
Note:
One locknut is from loose parts and
the other is used from earlier removal.
g014883
Figure 9
1. Front, right caster (caster
fork and wheel not shown
for clarity) 5. Bolt (3/8 x 1-1/4 inches)
2. Front hole on right side 6. Foot-assist lift pedal
bracket
3. Existing locknut (3/8 inch) 7. Existing hole in the bracket
4. Right mounting bracket 8. Locknut (3/8 inch) from
loose parts
7. Install the weight bracket to the mounting
brackets by aligning the outboard holes in the
bracket with the mounting brackets installed
previously (
Figure 10 ).
Note:
Ensure that the bracket is centered on
the frame.
8. Secure the weight bracket with 2 bolts (3/8 x
1 inch) and 2 locknuts (3/8 inch) as shown in
Figure 10 .
g014879
Figure 10
1. Locknut (3/8 inch) 4. Bolt (3/8 x 1 inch)
2. Weight bracket 5. Right mounting bracket
3. Left mounting bracket
7