Toro 79398, Operator'S Manual

Page: 8 / 20

9. Install a flat weight to the weight bracket and
move it rearward, flush with the bracket (
Figure
11 ).
g014880
Figure 11
1. Keyed crossbar
3. Suitcase weight
2. Flat weight
10. Install a suitcase weight in front of the flat weight
(
Figure 11 ).
11. Secure the weights to the weight bracket with a
keyed crossbar (
Figure 11 ). Install the bar and
rotate it 90 degrees downward to lock it in place.
12. Once all the weights and brackets have been
installed, check that all the fasteners are tight.
Tighten as necessary.
Important:
Whenever you remove the
bagger attachment, remember to remove the
front weights to return the proper stability
to the machine.
13. If you are installing this bagger on a machine
equipped with MyRIDE, perform the following
steps:
A. Install the previously removed 2 rail guards
using the 6 hex-washer head screws (1/4 x
13/16 inch) as shown in
Figure 4 .
B. Install the previously removed bolt and nut
to the front shock; refer to
Figure 3 .
2
Installing the Attachment
Mount
Parts needed for this procedure:
1 Stabilizer bracket
2 Carriage bolt (5/16 x 3/4 inch)
4 Locknut (5/16 inch)
2 Self-tapping screw (5/16 x 3/4 inch)
2 Bolt (5/16 x 1 inch)
1 Pivot frame
2 Hairpin cotter
2 Rod
2 Washer
1 Drawbar decal
Procedure
1. Install the stabilizer bracket to the engine guard
using 2 carriage bolts (5/16 x 3/4 inch) and 2
locknuts (5/16 inch) as shown in
Figure 12 .
g030494
Figure 12
1. Stabilizer bracket 3. Locknut (5/16 inch)
2. Carriage bolt (5/16 x 3/4
inch)
2. Install the pivot frame to the machine frame as
shown in
Figure 13 . Secure the pivot frame to
the machine frame using 2 bolts (5/16 x 1 inch)
and 2 locknuts (5/16 inch).
8