Toro 74952, Operator'S Manual

Page: 25 / 68

Adjusting the Height-of-Cut Pin
The height of cut is adjusted from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot and raise the
mower deck to the transport position (also the 140 mm
(5-1/2 inch) cutting-height position); refer to
Figure 26 .
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket (
Figure 26 ).
4. Select a hole in the height-of-cut bracket corresponding
to the height of cut desired, and insert the pin (
Figure
26 ).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 26
1. Deck-lift pedal 3. Transport lock
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-locked position,
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers as shown in Figure 27 ,
Figure 28 , and Figure 29 .
Figure 27
1. Anti-scalp roller 4. Flange nut
2. Spacer
5. Bolt
3. Bushing
Figure 28
1. Anti-scalp roller 3. Flange nut
2. Bushing 4. Bolt
Figure 29
1. Anti-scalp roller 4. Flange nut
2. Spacer 5. Bolt
3. Bushing
25