Toro 74952, Operator'S Manual

Page: 20 / 68

Operating the Throttle
The throttle control can be moved between Fast and Slow
positions ( Figure 15 ).
Always use the fast position when turning on the mower deck
with the blade-control switch (PTO).
G008946
Figure 15
Operating the Choke
Use the choke to start a cold engine.
1. If the engine is cold, use the choke to start the engine.
2. Pull up on the choke knob to engage the choke before
using the ignition switch (
Figure 16 ).
3. Push down on the choke to disengage the choke after
the engine has started (
Figure 16 ).
G008959
1
2
Figure 16
1. On 2. Off
Operating the Ignition Switch
1. Turn the ignition key to the Start position ( Figure 17 ).
When the engine starts, release the key.
Important:
Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, allow a 15 second cool-down period between
attempts. Failure to follow these instructions can
burn out the starter motor.
Note:
Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been completely without fuel.
ST
ART
RUN
ST
OP
G008947
Figure 17
2. To stop the engine, turn the ignition key to the stop
position.
Using the Fuel-Shutoff Valve
The fuel-shutoff valve is located under the seat. Move the
seat forward to access it.
Close the fuel-shutoff valve for transport, maintenance, and
storage.
Ensure that the fuel-shutoff valve is open when starting the
engine.
G008948
1
2
Figure 18
1. On 2. Off
20