g015373
1 2 3
2
Figure 71
1.
Switch
3.
Right motion control lever
in the neutral unlocked
position
2.
1/8 inch (3mm)
12. Tighten the switch screws.
Adjusting the Neutral Postion for the
Motion Control Levers
Important:
Ensure the tracking of the mower is
correct after adjusting the motion control levers.
Adjusting the tracking and aligning the motion
control levers front to back is the same procedure
(Figure 72).
Note:
Adjust the horizontal alignment before the front
to back alignment.
If the motion control levers do not align front to back,
or the right side control lever does not move easily into
the neutral lock position, adjustment is required.
1. After the horizontal alignment is finished, check the
front to back alignment (Figure 72).
g015241
Figure 72
1.
Left motion control lever
3.
Neutral locked position
2.
Right motion control lever
4.
Align the control levers
front to back
2. Rotate the right cable adjustment to place the right
motion control lever in the center of the neutral lock
slot in the control panel.
3. Rotate the left cable adjustment to place the left
motion control lever alignment equal with the
right motion control lever. This will provide an
approximate equal tracking of the left wheel speed
to the right wheel speed.
4. Check for proper tracking. Refer to Adjusting the
Tracking in the Maintenance Section.
g015369
1 2
Figure 73
1.
Left cable adjustment
2.
Right cable adjustment
49