Figure 54
1.
Positive Battery Post
3.
Red (+) Charger Lead
2.
Negative Battery Post
4.
Black (-) Charger Lead
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance. If a fuse blows, check the component
or circuit for a malfunction or short.
1. Release the cushion from the rear of the machine.
2. Pull out on the fuse to remove or replace it
3. Install the cover under the cusion.
Note:
Ensure the correct size fuse is install with the
correct wire color as shown in Figure 55.
g015401
1
Figure 55
1.
Fuses
Drive System
Maintenance
Adjusting the Tracking
Note:
Determine the left and right sides of the machine
from the normal operating position.
1. Push both control levers forward the same distance.
2. Check if the machine pulls to one side. If it does,
stop the machine and set the parking brake.
3. Release the cushion from the rear of the machine.
4. Rotate the right cable adjustment to position the
right motion control in the center of the control
panel neutral lock slot (Figure 57).
g015241
Figure 56
1.
Left motion control lever
3.
Neutral locked position
2.
Right motion control lever
4.
Align the control levers
front to back
5.
Rotate the left cable adjustment to match the left
wheel speed to the previously set right wheel speed.
Adjust in quarter-turn increments until the machine
tracks straight.
Note:
Only adjust the left cable to match the left
wheel speed to the right wheel speed. Do not adjust
the right wheel speed as this will position the right
motion control lever out of the center for the control
panel neutral lock slot.
40
