g015393
1
2
3
3
5
2
4
1
Figure 66
1.
1/8 inch (3mm) gap
needed between switch
and brake lever
4.
Switch button
2.
Brake lever
5.
Face of the switch
3.
Switch
Belt Maintenance
Replacing the Mower Deck
Belt
Service Interval:
Every 100 hours—Check the mower
deck belt.
Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks
are signs of a worn deck belt. Replace the deck belt if
any of these conditions are evident.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Unlatch and remove the belt covers.
4. Loosen the front idler pulley by loosening the nut.
5. Remove the worn mower belt (Figure 67).
6. Install the new mower belt around the deck pulleys
and clutch pulley (Figure 67 ).
7. Using a ratchet in the idler arm, tighten the idler
pulley until the spring is stretched 6-1/2 inches (165
mm) from hook to hook (Figure 67 ).
8. Tighten the front idler pulley by tightening the nut.
9. Install the belt covers onto the cutting unit and
secure the latches.
46
