Toro 41228, Installation Instructions Manual

Page: 8 / 16

6. Connect the right boom hose to the right side
solenoid valve assembly and the left supply hose to
the left side solenoid assembly.
7. Secure both hoses with small hose clamps
(Figure 16).
3
Wiring the Kit
Parts needed for this procedure:
1 Wiring harness
6 Hose clamp, small
12 Plastic ties
Procedure
Multi Pro 1200 or 1250 Turf Sprayer
1. Locate the labeled connectors wiring harness for the
foam marker solenoid and compressor and make
the connections to the compressor and the solenoid
located at the foam tank/compressor assembly
(Figure 17).
Note:
Both of the plug connections are identical
(Figure 17).
Figure 17
1. Wiring harness 3. Solenoid
2. Compressor
2. At the rear of the machine, plug the harness
connectors into the boom solenoid assemblies.
Plug the connector with the blue wire to the right
solenoid; plug the connector with the orange wire to
the left solenoid (Figure 18).
Figure 18
1. Mixer tee assembly 3. Wiring harness
2. Boom solenoids
Multi Pro 5600/5700 Turf Sprayer
1. Locate the wiring harness connectors furnished
with the vehicle for the foam marker and make the
connections to the compressor and the solenoid
located at the foam tank/compressor assembly
(Figure 19).
Note:
The connectors are located along the right
side frame rail strapped to the vehicle harness, where
the tank/compressor is installed. Both of the plug
connections are identical (Figure 19).
Figure 19
1. Wiring harness
3. Solenoid
2. Compressor
2. Locate the wiring harness connector furnished with
the vehicle for the foam marker boom solenoid at
the center section of the boom (Figure 20).
8