Toro 38860, Manual

Page: 23 / 164

g016646
Figure 33
3. Remove and discard the old spark plug.
Note:
You will need a ratchet wrench extension
to remove the spark plug.
4. Set the gap between the electrodes on a new
spark plug at 0.76 mm (0.030 inch) as shown
in
Figure 34 .
g001029
Figure 34
1. 0.76 mm (0.030 inch)
5. Install the new spark plug, tighten it firmly, and
attach the ignition wire to the spark plug.
Note:
Ensure that the ignition wire snaps
completely into place on the spark plug.
Replacing the Drive Belts
If the auger/impeller drive belt or the traction-drive belt
becomes worn, oil-soaked, or otherwise damaged,
have an Authorized Service Dealer replace the belt.
21