Preventing Freeze-up
•
In snowy and cold conditions, some controls and moving
parts may freeze. Do not use excessive force when
trying to operate frozen controls. If you have difficulty
operating any control or part, start the engine and let it
run for a few minutes.
•
After using the machine, let the engine run for a few
minutes to prevent moving parts from freezing. Engage
the broom to clear any remaining snow from inside the
housing. Stop the engine and wait for all moving parts to
stop, and disconnect the spark-plug wire. Remove all ice,
snow, or other debris from the machine.
•
Connect the spark-plug wire. With the engine switch in
the O
FF
position, pull the recoil-starter handle several
times to prevent the recoil starter from freezing up.
Transporting the Machine
WARNING
Using ramps that are not strong enough or properly
supported to load the machine onto the transport
vehicle could be dangerous. The ramps could
collapse, causing the machine to fall, which could
cause injury.
•
Use proper ramps that are secured to the truck
or trailer.
•
Keep feet and legs out from under the machine
when loading and unloading.
Preparing to Transport the Machine
Perform the following before transporting the machine:
•
Be sure that the fuel-shutoff valve is closed.
•
Use a heavy-duty trailer to transport the machine. Place
the machine in either a forward or reverse gear, then
block the wheels.
•
Securely fasten the machine to the trailer with straps,
chains, cables, or ropes.
•
Be sure that the trailer has all the necessary lighting and
marking as required by law.
17
