Toro 38700, Operator'S Manual

Page: 26 / 32

Figure 39
1. Spacer
4. Washer
2. Pulley shield 5. Bolt
3. Belt guide
3. Slip the belt forward over the forward groove of the
engine pulley (
Figure 40 ).
Figure 40
1. Engine pulley 3. Broom-gearbox pulley
2. Broom drive belt 4. Traction-control bracket
4. Slip the belt off of the broom-gearbox pulley,
move the belt rearward between the pulley and the
traction-control bracket, and remove the belt from the
machine (
Figure 40 ).
Installing the Broom-Drive Belt
1. Align the replacement belt between the pulley and the
traction-control bracket (
Figure 40 ).
2. Slip the belt onto the groove at the bottom of the
broom-gearbox pulley (
Figure 40 ).
3. Slip the belt onto the forward groove of the engine
pulley (
Figure 40 ).
Note:
Ensure that the belt is not twisted.
4. Align the spacer between the engine and the pulley
shined and align the holes in the spacer, engine, and
shield (
Figure 39 ).
5. Secure the pulley guide to the machine with the bolts
and washers (
Figure 39 ) that you removed in step 2 of
Removing the Broom-Drive Belt (page 25) .
Removing the Traction Belt
1. Remove the broom-drive belt; refer to Removing the
Broom-Drive Belt (page 25) .
2. Remove the hairpin from the traction-control rod
(
Figure 41 ).
Figure 41
1. Hairpin 3. Traction-control bracket
2. Traction-control rod
3. Remove traction-control rod from the traction-control
bracket by moving the rod inward (
Figure 41 ).
4. Pivot the traction-control bracket and traction pulley
forward (
Figure 42 ).
Figure 42
1. Tension pulley 4. Traction pulley
2. Rear groove (engine
pulley)
5. Traction-control bracket
3. Traction belt
5. Pull the tension pulley outward ( Figure 42 ).
26