Toro 31598N, Operator'S Manual

Page: 54 / 68

Figure 83
1. Hydraulic motor 2. Mounting bolts
5. Remove the old belt from around the spindle pulleys
and idler pulley.
6. Route the new belt around the spindle pulleys and idler
pulley assembly as shown in
Figure 84 .
114-0922
Figure 84
7. Readjust the idler pulley stop screw and tighten the
jam nuts.
Side Cutting Decks
Note:
To remove the lower belt, the upper belt must first
be removed.
1. Lower the cutting unit to the shop floor. Remove the
belt covers from the top of the cutting unit and set the
covers aside.
2. Remove the bolts securing the hydraulic motor to the
cutting unit (
Figure 83 ). Lift the motor off of the
cutting unit and lay it on top of the cutting unit.
3. Using a ratchet wrench or similar tool, move the idler
pulleys (
Figure 85 ) away from the drive belt to release
the belt tension and allow the belt to be slipped off
the pulleys.
Figure 85
1. Idler pulleys
4. Remove the old belt from around the spindle pulleys
and idler pulley.
5. Route the new belt around the spindle pulleys and idler
pulley assembly as shown in
Figure 86 and Figure 87 .
Figure 86
Right side deck
Figure 87
Left side deck
54