g021 156
Figure 75
1.
Drain plug
2.
Brake housing
4.
When all of the oil has drained from both locations,
re-install the plug in the brake housing.
5.
Rotate the wheel until the open holes in the planetary
are at the 11 and 1 o'clock position (
).
G024858
1
Figure 76
1.
Holes at the 11 and 1 o'clock position
6.
Through either open hole, slowly fill the planetary
with .53-.59 liter (18–20 ounces) of high quality SAE
85W-140 wt. gear lube.
7.
Reinstall the plugs.
8.
Repeat the procedure on the opposite planetary/brake
assembly
Checking the Rear Wheel
Toe-In
Service Interval:
Every 1,000 hours—Check the rear wheel
toe-in.
After every 1000 operating hours or annually, check the rear
wheel toe-in.
1.
Measure the center-to-center distance (at axle height) at
the front and rear of the steering tires (
). The
front measurement must be no greater than 3 mm (1/8
inch) less than the rear measurement.
Figure 77
1.
Center to center distance
2.
Tie rod clamps
2.
To adjust, loosen the clamps at both ends of the tie
rods (
).
3.
Rotate the tie rod end to move the front of the tire
inward or outward.
4.
Tighten the tie rod clamps when the adjustment is
correct.
50
