Toro 315000001, Operator'S Manual

Page: 18 / 32

8
Installing the Upper Tee
Assembly
Parts needed for this procedure:
1 Inlet hose 2.5 x 66 cm (1 x 26 inch)
2 Hose clamp
2 90° hub fitting
4 Large O-ring
1 T-Fitting (upper)
3 Retainer
1 Reducer hub
1 Small O-ring
1 Transfer hose 1.9 x 61 cm (3/4 x 24 inch)
1 Hub connector
Removing the Inlet Hose
1. Remove the flange clamp, gasket, flanged elbow, and
inlet hose from the pressure filter head (A of
Figure 35 ).
Note:
Retain the gasket and flange clamp for
installation later.
Figure 35
1. Inlet hose assembly 5. Pressure filter head
2. Flanged elbow (machine) 6. Retainer
3. Flange clamp 7. Lower T-fitting
4. Gasket 8. Straight-hub fitting (inlet
hose)
2. Remove the retainer that secures the straight-hub
fitting of the inlet hose to the lower T-fitting of the
sprayer system and remove the inlet hose from the
machine (B of
Figure 35 )
Note:
Retain the retainer for installation in Installing
the Upper T-fitting and Inlet Hose (page 20) .
3. Remove the flanged elbow and hose clamp from the
inlet hose (
Figure 35 ).
Note:
Retain the flanged elbow and hose clamp;
discard the old inlet hose and straight-barbed fitting.
18