Toro 315000001, Operator'S Manual

Page: 11 / 32

3
Installing the Rinse Nozzles
Parts needed for this procedure:
2 90° barbed fitting (3/4 inch NPT x 3/4 inch)
2 Plastic flange nut
2 Bulkhead fitting
2 Rinse nozzle
2 Bushing
2 Rinse vane
2 Shoulder bolt
Drilling the Main Tank
1. Open the tank lid and remove the strainer basket.
2. Locate the 2 drill marks on the main tank ( Figure 16 ).
1
G022212
Figure 16
1. Drill marks
3. Use a 4 cm (1-5/8 inch) hole saw to drill a hole at each
drill mark.
Note:
Place a receptacle inside the tank and below the
areas to be drilled to catch any debris created during
the cutting.
Important:
Debris left inside a tank could clog
and damage the spray system during operation.
Note:
Drilling counter clockwise will make drilling
easier.
Installing the Nozzles
Note:
Apply PTFE tape to the threads of the taper-threaded
fittings used in the sprayer and rinse systems.
1. Assemble the 2 rinse nozzles as shown in Figure 17 .
G022281
1
2
3
4
5
Figure 17
1. Bulkhead fitting 4. Rinse vane
2. Rinse nozzle 5. Shoulder bolt
3. Bushing
2. Open the cover of the sprayer tank.
3. Assemble the nozzle assemblies up through the drilled
holes (
Figure 18 ).
G022282
1
2
3
Figure 18
1. Bulkhead fitting 3. Rinse-nozzle assembly
2. Plastic flange nut
4. At top of the tank, install the plastic flange nuts over
the exposed threads of the bulkhead fittings for the
rinse nozzles(
Figure 18 ).
Note:
Ensure that the seal is seated flush between the
bulkhead fitting and the underside of the tank.
11