Toro 31500000, Operator'S Manual

Page: 27 / 32

Figure 37
1. Screw 4. Steel gasket
2. Cover 5. Batteries
3. Seal 6. Handheld remote
2. Remove the discharged batteries and properly dispose
in accordance with local regulations.
3. Plug each fresh battery into a terminal cradle observing
proper polarity.
Note:
If the batteries are improperly installed, the unit
will not be damaged, but it will fail to operate.
4. If you accidentally removed the rubber seal and the
steel gasket, replace them carefully into the channel in
the handheld remote.
5. Replace the cover and secure it with the 6 screws
removed previously (
Figure 37 ) and torque them to 1.5
to 1.7 N-m (13 to 15 in-lb).
Fuses
Engine
A 15 amp in-line fuse is incorporated into the engine wiring
harness (
Figure 38 ).
G030098
Figure 38
1. Fuse
Receiver
A fuse block is incorporated into the receiver wire harness.
It is located behind the receiver on the right side of control
tower (
Figure 39 ).
Figure 39
1. Fuse
27