Figure 10
1.
Bolt
5.
Spring installed
2.
Spacer
6.
Grass deflector
3.
Locknut
7.
L
-end of spring; place
it behind the deck edge
before installing the bolt.
4.
Spring
8.
J
-hook end of spring
2.
Slide the blower assembly peg into the pivot hole
(
).
Figure 11
Model 31213 shown
1.
Blower assembly
3.
Pivot hole
2.
Mower deck
4.
Blower assembly peg
3.
Close the blower assembly to see if the latches are
adjusted correctly. Loosen or tighten the bolt so that
the latches firmly hold the blower assembly against the
mower deck but can be released by hand (
Figure 12
Model 31213 shown
1.
Latch
3.
Blower assembly
2.
Bolt
4.
Install the spring as shown in
.
Note:
Make sure that the hooks are in the correct
position.
Figure 13
1.
Spring-loaded idler pulley
3.
Long hook end
2.
Short hook end
5.
Pull the spring-loaded idler pulley back and route the
belt around the mower deck pulley. Ensure that the
belt is routed around the blower pulleys correctly
(
).
7
