Toro 30506, Operator'S Manual

Page: 12 / 20

g012551
Figure 23
1. Bumper
3. Using both mounting plates of the bumper as
templates, locate, mark, and drill 3 additional
11/32 inch diameter holes through both walls of
the front and rear castor arm brackets.
11
Installing the New Deck
Cover
Parts needed for this procedure:
1 Trim molding
1 Deck cover
Procedure
1. Insert a trim molding onto the right bridge bar, so
the side of the spring bracket is 10 cm (4 inches)
to the far edge of the trim molding (
Figure 24 ).
g029097
Figure 24
1. Trim molding 3. Bolt
2. Cover
2. Hook the rear of the deck cover ( Figure 24 ) onto
the rear channel pin while aligning the cover
mounting bolt with the hole in the right castor
arm. The cover is to rest on the trim molding.
Adjust the molding as required.
3. Secure the cover to the right castor arm with
the bolt.
12
Installing the New Safety
Guards
Parts needed for this procedure:
1 Belt guard
1 Pulley guard
Procedure
1. Install the belt guard onto the machine ( Figure
25 ).
Note:
Use existing hardware on the machine
by removing it and using it to install the guard.
g029098
Figure 25
1. Belt guard 3. Bolt
2. Nut
2. Install the pulley guard onto the machine ( Figure
26 ).
12