Toro 23823/A, Software Manual

Page: 2 / 16

g213150
Figure 3
1. Pull pipe 4. Thrust force
2. Push pipe
5. Drill speed (rpm)
3. Rotary torque
SmartTouch™ Home
Screen
SmartTouch mode allows the operator to load and
unload pipes from the rod box with less joystick
operation to reduce operator fatigue.
Use the Carriage Settings Screen (page 10) to turn
SmartTouch mode on and off.
Note:
The Push/Pull Icons have a green background
when SmartTouch mode is on and a ribbon appears
at the bottom of the screen showing a sequence of
the steps.
Important:
Never switch between Push/Pull
modes during the chosen operation. Use neutral
(manual) mode to switch between Push/Pull; refer
to
Carriage Settings Screen (page 10) to turn
SmartTouch mode off.
The SmartTouch screens appears along the bottom of
the home screen as shown below.
g231722
Figure 4
Pulling Pipe in SmartTouch Mode
Start the SmartTouch mode with the cam assembly in
the home position (row 4 of the pipe box).
Important:
Ensure that you hold the lower section
of the cam rocker switch, on the left joystick,
completely down until the action is complete in
each step (
Figure 5 ).
g210060
Figure 5
Hold the upper section of the cam rocker switch,
on the left joystick, completely down until all
actions are complete to go to the previous step in
the sequence (
Figure 6 ).
g210061
Figure 6
1. Push button 1 to select the pull pipe option
(
Figure 7 ).
2