
Figure 18
1.
Hydraulic fluid check bubble
4. Remove the cover plate; refer to
Removing the Cover Plate (page 22).
5. Clean the area around the filler neck of the hydraulic
tank and remove the cap and filter from the filler
neck using a socket (Figure 19).
Figure 19
1.
Filler neck cap
2.
Hydraulic fluid filter
6. If the level is low, add fluid until it is visible in the
glass bubble.
7. Install the cap and filter on the filler neck and torque
bolt on top to 110 to 140 inch-lb (13 to 15.5 N-m).
8. Install the cover plate; refer to
Installing the Cover Plate (page 22).
Starting and Stopping the
Engine
Starting the Engine
1. Move the throttle lever midway between Slow and
Fast positions (Figure 20).
g013178
1
2
3
Figure 20
1.
Throttle lever
3.
Key
2.
Choke lever
2. Move the choke lever to the On position (Figure 20).
Note:
A warm or hot engine may not require
choking.
3. Turn the key to the On position (Figure 20). When
the engine starts, release the key.
Important:
Do not engage the starter for more
than 10 seconds at a time. If the engine fails
to start, allow a 30 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
4. Gradually move the choke lever to the Off position
(Figure 20). If the engine stalls or hesitates, engage
the choke again until the engine warms up.
5. Move the throttle lever to the desired setting
Important:
If the engine is run at high speeds
when the hydraulic system is cold (i.e., when
the ambient air temperature is near freezing or
lower), hydraulic system damage could occur.
When starting the engine in cold conditions,
allow the engine to run in the middle throttle
position for 2 to 5 minutes before moving the
throttle to fast (rabbit).
Note:
If the outdoor temperature is below freezing,
store the machine in a garage to keep it warmer and
aid in starting.
Stopping the Engine
1. Stop the grinder and lower it to the ground.
2. Move the throttle lever to the Slow position
17
Summary of Contents for 23210
Page 41: ...Schematics g013418 Electrical Schematic Rev A 41 ...
Page 42: ...g013419 Hydraulic Schematic Rev A 42 ...
Page 43: ...Notes 43 ...