Toro 22337CP, Operator'S Manual

Page: 22 / 44

CAUTION
A child or untrained bystander could attempt to
operate the traction unit and be injured.
Remove the key from the switch when leaving
the traction unit, even if just for a few seconds.
Moving a Non-functioning
Traction Unit
Important:
Do not tow or pull the traction
unit without first opening the tow valves, or the
hydraulic system will be damaged.
1. Stop the engine.
2. Remove the plug covering each tow valve, located
under each fuel tank (Figure 18).
Figure 18
1. Tow valve 2. Plug
3. Loosen the jam nut on each tow valve.
4. Turn each valve counterclockwise one turn with a
hex wrench to open them.
5. Tow the traction unit as required.
Important:
Do not exceed 3 mph when towing.
6. When you have repaired the traction unit, close the
tow valves and tighten the jam nuts.
Important:
Do not over tighten the tow valves.
7. Replace the plugs.
Using the Cylinder Locks
WARNING
The loader arms may lower when in the raised
position crushing anyone under them.
Install the cylinder locks before performing
maintenance that requires raised loader arms.
Installing the Cylinder Locks
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Stop the engine.
4. Position a loader arm cylinder lock over each lift
cylinder rod (Figure 19).
5. Secure each loader arm cylinder lock with a clevis
pin and cotter pin (Figure 19).
Figure 19
1. Cylinder lock 4. Clevis pin
2. Lift cylinder 5. Lift cylinder rod
3. Hairpin cotter
6. With the engine off, lower the loader arms.
Removing/Storing the Cylinder Lock
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Stop the engine.
4. Remove the clevis pin and cotter pin securing each
cylinder lock.
5. Remove the cylinder locks.
6. Lower the loader arms.
7. Install the cylinder locks over the hydraulic hoses
and secure them with the clevis pins and cotter pins
(Figure 20).
22