Note:
The farther you move the traction control
levers in either direction, the faster the traction unit
will move in that direction.
•
To slow or stop
, move the traction control levers
to neutral.
Attachment Tilt Lever
•
To tilt the attachment forward, slowly push the
attachment tilt lever forward.
•
To tilt the attachment rearward, slowly pull the
attachment tilt lever rearward.
Loader Arm Lever
•
To lower the loader arms, slowly push the loader
arm lever forward.
•
To raise the loader arms, slowly pull the loader arm
lever rearward.
Loader Valve Lock
The loader valve lock secures the loader arm and
attachment tilt levers so that you cannot push them
forward. This helps to ensure that no one will
accidentally lower the loader arms during maintenance.
Secure the loader arms with the lock anytime you need
to stop the machine with the loader arms raised.
To set the lock, pull it back and all the way down against
the levers (Fig. 13).
Note:
You will need to move the levers rearward to
engage or disengage the loader valve lock.
Figure 8
1.
Loader valve lock,
engaged
2.
Loader valve lock,
disengaged
Auxiliary Hydraulics Lever
•
To operate a hydraulic attachment in forward
direction, slowly pull the auxiliary hydraulics lever
upward and then rearward.
•
To operate a hydraulic attachment in reverse
direction, slowly pull the auxiliary hydraulics lever
upward and then push it forward. This is also called
the detent position because it does not require
operator presence.
Speed Selector Lever
WARNING
If you move the speed selector lever while the
traction unit is in motion, the traction unit will
either stop suddenly or accelerate quickly. If you
operate the traction unit with the speed selector
lever in an intermediate position, the traction unit
will operate erratically and may be damaged. You
could lose control of the traction unit and injure
bystanders or yourself.
•
Do not move the speed selector lever when the
traction unit is in motion.
•
Do not operate the traction unit when the speed
selector is in any intermediate position (i.e.,
any position other than fully forward or fully
rearward).
•
Move the speed selector lever to the forward position
to set the traction drive, loader arms, and attachment
tilt to high speed and the auxiliary hydraulics to low
speed.
•
Move the speed selector lever to the rearward
position to set the auxiliary hydraulics to high speed
and the traction drive, loader arms, and attachment
tilt to low speed.
Hour Meter
The hour meter displays the number of hours of
operation that have been logged on the traction unit.
After 50 hours and every 75 hours thereafter (that is at
50, 125, 200, etc.) the hour meter displays SVC on the
lower left side of the screen to remind you to change the
oil and perform the required maintenance. After every
400 hours (400, 800, 1200, etc.), the hour meter displays
SVC on the lower right side of the screen to remind
you to perform the maintenance procedures based on a
400 hour schedule. These reminders come on starting
three hours prior to the service interval time and flash at
regular intervals for six hours.
15
Summary of Contents for 22337CP
