Procedure
Description
Qty.
Use
Bolt (1/4 x 1-1/2 inches)
4
Jam nut
4
9
Shaft clamp
4
Install the groomer assembly (ordered
separately) and optional broomer kit.
10
Hydraulic fitting—45° (Part No.
340–101; sold separately)
1
Install the angled fitting (for Reelmaster
3550 and 3555 machines, #1 front,
center cutting location and kit Model
133-0150).
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
2
Gathering the Tools
Required for Setup
No Parts Required
Procedure
•
Torque wrench—5.2 to 6.8 N∙m (46 to 60 in-lb)
•
Torque wrench—115 to 129 N∙m (85 to 95 ft-lb)
•
Torque wrench—135 to 150 N∙m (100 to 110 ft-lb)
•
Torque wrench—150 to 163 N∙m (110 to 120 ft-lb)
•
Reel driveshaft tool, Part No. TOR4112 (used only
on 5-inch reels)
•
Reel driveshaft tool, Part No. TOR4074 (used only
on 7-inch reels)
•
Adapter wrench tool, Part No. 137-0921
3
Determining the Setup
No Parts Required
Procedure
Use the following diagram to determine the position
of the groomer kit and reel motors.
g027662
Figure 1
1.
Cutting unit 1
5.
Cutting unit 5
2.
Cutting unit 2
6.
Reel motor
3.
Cutting unit 3
7.
Right groomer kit
4.
Cutting unit 4
8.
Left groomer kit
Note:
If you are installing a groomer kit and a rear
roller-brush kit on the cutting unit, install the groomer
kit first.
2
